Digital Design Engineer
The Digital/ embedded
Design Engineers will leverage their creative design and development expertise
to help develop innovative solutions for the application of space systems
technologies. You will work in small collaborative groups through all stages of
the launch vehicle and spacecraft design, including conceptual flight computer
and ground support control system architecture, preliminary design, detailed
design, fabrication and test procedure writing and liaison manufacturing and
test support. You will have full ownership of your project from the
initial concept through all phases of the design, analysis, manufacturing, and
final integration of your module(s) and systems through Launch and on-orbit
support,
Minimum Requirements and
Responsibilities:
Design, analyze,
implement, troubleshoot, optimize and test of digital and embedded
computing/signal processing for flight hardware and ground equipment utilizing
PowerPC, CorIQ, FPGA, ASIC, SOM and ARM based
Microcontrollers and Computers.
Digital system and
component design, including core analysis, IP development, RTL/VHDL coding,
analysis and simulation.
Competent in end-to-end
definition, requirement generation, block diagram design, component selection
and evaluation, detailed schematic design, board layout and routing, electrical
and VHDL/MATLAB simulation and analysis, breadboarding,
testing and troubleshooting of system on module computers and embedded
processors.
Fluency and competency
in C, C++ languages in addition to Linux and RTOS operating systems
Fully fluent and
competent in usage of digital signal processing test equipment, such as logic
analyzers, oscilloscopes, lab test equipment etc.
Competent and fluent in
MATLAB (or Maple, Mathematica), Verilog, and other HDL
Experienced in design,
development and implementation of DSP based embedded systems, single board
computers, I/O and peripheral development
Experienced in design
and development of local communication protocols, CAN, 1553, 1394, etc.
Knowledge of design and
development of control systems such as those used in robotics and guidance and
navigation is highly desirable
Minimum Qualifications:
Bachelor of Science in
Electrical Engineering (EE) or Electrical and Computer Engineering (ECE)
MS/PhD in Electrical
Engineering is preferred
Minimum of 2 years of
industry Digital circuit and system design and development is required.
Candidate must demonstrate complete proficiency in digital and computer
hardware design and development, analysis and simulation in addition to
troubleshooting and test of digital and computer hardware experience.
Benefits - Full
5+ to 7 years
experience
Minimum Education - Bachelor's Degree
TEXAS
